{
  "schema_version": "1.0",
  "rubrics": [
    {
      "id": "R1",
      "requirement": "The drawing shall contain a single front elevation showing a podium, a tower shaft and a recessed rooftop crown/penthouse."
    },
    {
      "id": "R2",
      "requirement": "The drawing shall show six cantilevered horizontal balcony/slab bands within a canted (inclined) frame on the tower."
    },
    {
      "id": "R3",
      "requirement": "The drawing shall show a vertical feature column at the right side of the tower and a brick-clad pier with a brick top band."
    },
    {
      "id": "R4",
      "requirement": "The drawing shall show podium glazing with curtain-wall grids and two entrance double doors."
    },
    {
      "id": "R5",
      "requirement": "The drawing shall show a stepped rooftop with gridded parapet tiers and a sloped mechanical penthouse at the top."
    },
    {
      "id": "R6",
      "requirement": "The drawing shall include a rectangular border frame enclosing the elevation and a continuous ground/plinth line."
    },
    {
      "id": "R7",
      "requirement": "The drawing shall use inches as its units, at full size, with an overall extent of approximately 1710.08 wide by 1813.9 high."
    },
    {
      "id": "R8",
      "requirement": "The drawing shall contain layer A-ELEV with ACI 7, Continuous linetype and 0.35 mm lineweight, holding the building outline linework (lines and polylines)."
    },
    {
      "id": "R9",
      "requirement": "The drawing shall contain layer A-GLAZ with ACI 4, Continuous linetype and 0.18 mm lineweight, holding the glazing grid lines."
    },
    {
      "id": "R10",
      "requirement": "The drawing shall contain layer A-DOOR with ACI 3, Continuous linetype and 0.25 mm lineweight, holding the door linework."
    },
    {
      "id": "R11",
      "requirement": "The drawing shall contain layer A-ELEV-PATT with ACI 8, Continuous linetype and 0.13 mm lineweight, holding all hatches."
    },
    {
      "id": "R12",
      "requirement": "The drawing shall fill the feature column with native BOX pattern hatches (3 hatch objects) on A-ELEV-PATT, not exploded lines."
    },
    {
      "id": "R13",
      "requirement": "The drawing shall fill the brick areas with native AR-BRSTD pattern hatches (2 hatch objects) on A-ELEV-PATT, not exploded lines."
    },
    {
      "id": "R14",
      "requirement": "The drawing shall have no geometry on layer 0."
    }
  ]
}